Optimization of Higher-Order Harmonic Surface Tessellations for Additively Manufactured Air-to-Air Heat Exchangers

Air-to-air heat exchangers are vital for energy recovery and thermal management but often suffer from reduced effectiveness, high pressure losses, and increased pumping power in conventional designs. Advances in additive manufacturing have enabled nature-inspired geometries, such as lattice and triply periodic minimal surface (TPMS) structures, which enhance heat transfer through complex first-order surfaces but frequently cause excessive pressure drops. This study proposes an optimized higher-order harmonic heat-transfer surface tessellation developed through an optimization framework integrating analytical and numerical methods. The goal is to improve the overall thermal-hydraulic performance of the heat exchanger over a range of operating conditions. Results of sensitivity analysis show that secondary surface modification of this type can yield significant increase in the effectiveness reaching up to 70% although with associated increase in the pressure drop. The secondary surface wave frequency was found to be a more important control parameter than the amplitude in achieving high thermal-hydraulic performance. Additionally, we show that the optimized second order harmonic-type structure achieved relatively higher effectiveness and lower pressure-drop than the gyroid structure in the turbulent flow regime for Re>=7000. Although the gyroid TPMS structure had relatively higher effectiveness in the laminar and weakly turbulent flow regime, the associated pressure drop was found to be significantly higher than that of the harmonic-type structure.